INVESTIGATION PROGRESS

Date Status
19 Dec 2018 Termination
19 Dec 2013 Definitive duty
19 Jul 2013 Preliminary duty
12 Feb 2013 Initiation

IMPLEMENTATION LEVEL

National

AFFECTED FLOW

Inflow

ANNOUNCED AS TEMPORARY

No

NON-TRADE-RELATED RATIONALE

No

ELIGIBLE FIRMS

all

JUMBO

No

TARIFF PEAK

No
← back to the state act
Inception date: 19 Jul 2013 | Removal date: 19 Dec 2018
Still in force

Anti-dumping

On February 12, 2013, the Australian Customs and Border Protection Service initiated an anti-dumping investigation on imports of flat rolled products of iron, non-alloy steel or non-heat treated alloy steel of a kind commonly referred to as Quench and Tempered (Q&T) Green Feed (of a width greater than 600mm, with a thickness equal to or greater than 4.75mm, not further worked than hot rolled, not in coils, with or without patterns in relief) from China, Chinese Taipei, Indonesia, Japan and South Korea (Australian Customs Dumping Notice No. 2013/18).
The following goods are excluded from the investigation: 250 megapascal (MPa) yield strength grades of plate steel with a thickness greater than 150mm, 350 MPa yield strength grades of plate steel with a thickness greater than 100mm, Q & T Green Feed grades of plate steel with a thickness greater than 105mm and heat treated Q & T grades of plate steel.
The products subject to investigation are classified under the following HS codes: 7208.4000, 7208.5100, 7208.5200 and 7225.4000.
The complaint was lodged on December 21, 2012 by Bluescope Steel Limited.
An anti-subsidy investigation was simultaneously initiated on imports of the same products originating in China (see measure 7285).
 
On February 28, 2013, the Australian Customs and Border Protection Service published a notice to clarify which goods are subject to investigation (Australian Customs Dumping Notice No. 2013/20).
 
On July 19, 2013, the Australian authorities published the Preliminary Affirmative Determination Report (PAD Report No. 198) and decided to impose a provisional anti-dumping duty on imports of hot rolled plate steel originating in China, Indonesia, Japan and South Korea (Anti-dumping Notice No. 2013/60, 19.07.2013). The rate of the duty imposed on imports originating in China is 26%, at the exception of the company Shandong Iron and Steel Company Limited, Jinan Company (JIGANG) whose exports are not subject to the payment of a duty. The rate of the duty imposed on imports originating in Indonesia ranges from 8.6% to 19%, depending on the manufacturer/exporter. The rate of the duty imposed on imports originating in Japan is 14.3%. The rate of the duty imposed on imports originating in South Korea is 20.6%, at the exception of the company Dongkuk Steel Mill Ltd (DSM) whose exports are subject to a duty of 18.4% and at the exception of the companies Hyundai Steel Company and POSCO whose exports are not subject to the payment of a duty. No duty was imposed on imports originating in Chinese Taipei since it has been found that exports originating in this country were not dumped.
 
On September 10, 2013, the Australian Anti-Dumping Commission decided to terminate the investigation regarding imports originating in Chinese Taipei after having found that the total volume of goods that have been exported to Australia over a reasonable examination period from Chinese Taipei that have been dumped from all Taiwanese exporters is negligible (Anti-Dumping Notice No. 2013/67). The Australian Anti-Dumping Commission also decided to terminate the investigation regarding goods originating in South Korea and produced by Hyundai Steel Company and POSCO after having come to the conclusion that there has been no dumping by those exporters. Finally, the Australian Anti-Dumping Commission also decided to terminate the investigation regarding goods originating in China and exported by Shandong Iron and Steel, Jinan Company (JIGANG) after having found that the dumping margin is less than 2%.
 
On December 19, 2013, the Australian authorities imposed a definitive anti-dumping duty on the goods subject to investigation (Anti-Dumping Notice No. 2013/72). The rate of the duty imposed on imports originating in South Korea (excepting Hyundai Steel Company and POSCO) is 20.6%, at the exception of the company Dongkuk Steel Mill, Co., Ltd. whose exports are subject to a duty of 18.4%. The rate of duty imposed on imports originating in Japan is 14.3%. The rate of the duty imposed on imports originating in Indonesia ranges from 8.6% to 19.3%, depending on the manufacturer/exporter. The rate of the duty imposed on imports originating in China (exception JIGANG) is 54.9%; this duty is, however, a combination of an anti-dumping duty and of a countervailing duty imposed simultaneously (see measure 7285). The dumping margin of imports originating in China has been found to be 'only' 22.1% while the subsidy margin has been found to be 36.9%.

On 19 December 2018, the Australian authorities terminated the definitive duty imposed on imports of the subject good from Indonesia, Japan, the Republic of Korea and China. The duty was terminated as it was set to expire.
 

AFFECTED COUNTRIES

MAP
TABLE
EXPORT

AFFECTED SECTORS AND PRODUCTS

412 Products of iron or steel
7208 Flatrolled products of iron or nonalloy steel, of a width of 600 mm or more, hotrolled, not clad, plated or coated.
720840 Not in coils, not further worked than hotrolled, with patterns in relief
720851 Of a thickness exceeding 10 mm
720852 Of a thickness of 4.75 mm or more but not exceeding 10 mm
7225 Flatrolled products of other alloy steel, of a width of 600 mm or more.
722540 Other, not further worked than hotrolled, not in coils

Please report this page in case you detect an inaccuracy in its content.